Smoking area near here

The glow is cleaned with ________, the total glow cleaning for you who love cleanliness!

The glow is cleaned with ________, the total glow cleaning for you who love cleanliness! glo
glo glo Rajkisto glo cool gloAir glo Kent glo convenience storeIncluding PR
⚡ 【早見表】グロー(glo)の正しい掃除方法|専用ブラシと綿棒での手入れ手順
掃除のタイミングスティック5〜20本吸引ごと(または1箱吸い終わるごと)に、本体が完全に冷めてから底面のクリーニングドアを開けて清掃します。
付属ブラシと綿棒の使い分けまず付属ブラシを上下から通して葉カスを落とし、頑固なヤニ汚れは無水エタノールをほんの少し含ませた細軸綿棒で拭き取ります。
故障を防ぐ注意点内部にアルコール液が垂れると基板故障の原因になるため、綿棒は湿らせる程度に絞り、清掃後はしっかり乾燥させてから充電・使用してください。

Good evening,Heated cigarette blogger Genki (@MOQLOG_JP)It is.

I want my cigarettes to taste good anyway.

Heated cigarettes, not only Glow, but also Icos and Plume-es, must be cleaned to enjoy their original flavor.

This time, I got this question from a reader, so I put it into practice!

I was wondering when I read the article about cleaning glow.
Can I use a stick that looks like a cotton swab to clean my Icos to clean my glow?
Thank you very much. m(_ _)m

Glow" cleaning finishing touches sent to those who are particular about cleaning.

I see...it's called wiping...so I did it right away!

It will be clean, though,Customer center told me I shouldn't put anything but brushes in it.Please implement at your own discretion.

Also, please refer to the article on disassembling glow, which also discusses cleaning with anhydrous ethanol.

Glow used for finishing

glo and cotton swabs

In my last issue, I wroteblowingI shined it up with an article on "ThegloUse the.

I haven't used it since I cleaned it in that article, so the assumption is that it has already been brushed and blown.

In case you are wondering, I also brushed & blew on the swab before sticking it in, but there is no sign of dirt.

Does a finishing swab really make sense?

Precautions

Claws inside the glo

The cleaning process itself is very simple, so to avoid anyone making the mistake of doing it out of the blue, go ahead and do it.important pointDescribe the.

While it is unlikely that a cotton swab cleaning will cause fatal damage, glow is not cheap.

Be careful of claws!

gloIn the hole where the neostick is inserted in theneostick(after a noun) to make sure that it does not slip outclose up (editing mark)is attached..

Therefore, when cleaning with cotton swabs, you need to be very careful not to break these claws.

Note that the early model I am using has four claws, but the newer model has four more smaller claws installed.

It is possible to suck even if the claw is broken, but if the part is broken, the tension will drop (sweat).

Baby cotton swabs are still the best!

I don't think anyone would use a regular cotton swab because you can't insert it through the cleaning flap as well as you can clean an Icos.baby cotton swab&ethanol anhydrideis good.

It is not impossible to swab a regular cotton swab through the Neostick insertion slot, but tragedy strikes when you try to remove the swab.

It got stuck in the claw I wrote about earlier and wouldn't come off. I tried it and broke out in a cold sweat, so please don't imitate me, everyone.

I managed to remove the claws by pressing down on the part where the claws meet with ultra-thin tweezers, but if I had not done a good job, the claws might have broken (sweat).

Start of finish cleaning!

First, clean the plug with a cotton swab.

Opening the slide and cleaning from the stick insertion slot with a cotton swab

First, insert a cotton swab from the Neostick insertion slot!

Since the shape is just like a tube, I had to grind quite a bit below the claws.

Dirt on the cotton swab after cleaning

I thought I had cleaned it up pretty well, but it is still so dirty.

It is believed to be yani that was stuck to the heating tube.

Please note that I am cleaning with Icos swabs this time because I thought they would look better pictorially.

Further cleaning from the bottom flap

Next, opening the bottom flap to clean from the air intake port

Now, turn the swab upside down and insert the reverse side of the swab.

To clean from the flap side, be careful to use a cotton swab of a size that can easily fit into the hole, and to pull it out without catching it when pulling it out.

Please note that if the tip of a cotton swab should come off, you will have a hard time getting it out.

Cotton swab after cleaning (bottom side)

I expected a bit of dirt to still be removed by cleaning from the Neostick insert, but it was still a bit dirty.

Unfortunately, it was proven that blowing alone was not enough to make it shiny (sweat).

Brushing & blowing alone will not make it shiny, cotton swabs are good for finishing!

To clean up the inside of the glow, summarize

The Glow formula states brushing only, but again, that is not enough to remove stains such as yanitori.

The reason it cannot be removed by brushing alone is that the glow of thetar, nicotine stainis mixed with water and becomes liquid..

By using cotton swabs to clean this time,I have found that blowing for simple cleaning and using "baby swabs" for serious cleaning is the way to go!.

However, blowing is no-risk and super easy to do, while cleaning with baby swabs is somewhat risky.

As I mentioned, the most important thing is to clean the room every day, because as long as you clean it properly, you will not have to spend so much time and effort.

Cotton swab cleaning is a must for cleaning enthusiasts, but at your own risk.

postscript

This time, a reader gave me a great tip and I discovered something new, thank you so much!

In fact, there were other people who told us about the mistakes they made when they started using glow.

It was a bit difficult to take pictures and I haven't been able to write about it, but I will share it when I get a good shot.

If you have any questions, failures, or interesting uses for glow, please let us know.

Thank you for your continued support.

Frequently Asked Questions

Q
Can I clean the glow with a cotton swab?
A

It will be clean, but customer center told me that I should not put anything other than brushes in it, please implement at your own discretion.

Q
What precautions should I take when cleaning glow with a cotton swab?
A

The hole where the Neostick is inserted has a claw to prevent the Neostick from falling out. Therefore, when cleaning with a cotton swab, you need to be very careful not to break the claws around the Neostick.

Q
How do I clean the glow with a special brush?
A

Open the cover on the top of the main unit and the cleaning flap on the bottom of the main unit and clean them with a special brush. If liquid gets on the cleaning flap, wipe it off with tissue paper, etc. It is recommended to wipe off the liquid on the cleaning flap and the bottom of the main unit after every 5 uses.

Q
How can I clean the inside of the glow?
A

The Glow formula states brushing only, but, again, that is not enough to remove yarns and other stains. Blowing is recommended for simple cleaning, and "baby cotton swabs" are recommended for serious cleaning.

How Was This Flavor?

Aggregates ratings in 1 click from users aged 20 or older who have actually used the selected brand. By pressing the button, you agree that you are 20 or older and that your response will be used for anonymous aggregation. Response counts are displayed from 5 or more. Options are limited to brands registered in the product master.

1 Did not suit me — 5 Liked it

When you select a brand, the average is displayed if there are 5 or more responses.

Also rate sweetness, menthol, etc.

Comment

en_USEnglish
Moclog is a blog about tobacco.
You are over 20 years old, correct?
No, sir.
🌐 English